Rogue Engineering Exhaust Rasp Pipe for 1999-2006 BMW M3 [E46] (RE.MID.E46M3.2)

We Price Match!

Speak with one of our Mod Experts

714.582.3330   or   Live Chat

We'll match or beat any competitor's price!


Some restrictions and exclusions apply.

Please see our full Price Match Policy for details.

$575.00
(No reviews yet) Write a Review
SKU:
Rogue-Engineering-E46-Rasp-Pipe-ER3

We Price Match!

Speak with one of our Mod Experts

714.582.3330   or   Live Chat

We'll match or beat any competitor's price!


Some restrictions and exclusions apply.

Please see our full Price Match Policy for details.

Shipping:
$40.00 (Fixed Shipping Cost)

WARNING: product may contain chemicals known to the State of California to cause cancer, birth defects, and/or reproductive harm.
For more information, go to www.P65Warnings.ca.gov.

DISCLAIMER: Products that affect or remove vehicle emissions equipment (Intakes, Manifolds, Tuners, etc) that do not have a CARB EO number may not be available for sale in the state of California. Please contact us if you are unsure if a product is available for sale in California. ModBargains complies with all EPA and CARB regulations.

Rogue Engineering Exhaust Rasp Pipe for 1999-2006 BMW M3 [E46]
Rogue Engineering is proud to introduce our E46 M3 Rasp Pipe,the sensible way of ridding your car of the factory exhaust rasp.  Finally, you can truly enjoy the sound of your M3 without the annoying rasp of the exhaust at the higher RPMs found in US-model E46 M3s.

BMW_E46_M3_Imola_Red_Mishimoto_Radiator_ForgestarF14_KW_V3_HRsways-19

If you have any questions on this Rogue Engineering E46 M3 Rasp Pipe please give us a call at 714-582-3330

For more information on this Rogue Engineering E46 M3 Rasp Pipe please Click Here

The Rogue Engineering E46 M3 Rasp Pipe is made to fit exactly like factory. Features of the unit include:
    • Fully mandrel bent tubing, no crimps or flattened areas.
  • 100% T-304 stainless steel construction, including flanges, internals
  • Weighs only 14.5 lbs. (factory weighs 19 lbs.)
  • Will not change ground clearance
  • Will not void factory warranty
  • Will not affect emissions
  • No permanent modifications required for installation

During development, Rogue Engineering was able to sufficiently tune out the factory rasp without the added expense of replacing another section of of the factory exhaust system. Because of the simplicity, installation can take as little as 20 minutes (with the car on the lift, with proper tools).
                                                                                                      

For those that looking to eliminate this tone from their E46 M3s, there are a few other choices in the marketplace.  However, the Rogue Engineering Rasp Pipe is one of the few that can truly say that performance is uninhibited by the installation of this item.  Other ""muffler style"" designs that use one piece units to try to achieve the same result as our product do so by lowering the cost of the item (it is cheaper to use one muffler than using two, regardless of size).  These do have negative effects, as seen in comparable products used in daily drivers.

Regardless of the exhaust system you choose, the Rogue Engineering Rasp Pipe will do its job in removing the raspy tone.

If you have any questions on this Rogue Engineering E46 M3 Rasp Pipe please give us a call at 714-582-3330

 

Rogue Engineering E46 M3 Rasp Pipe Video

Mod Category:
Exhaust
Mod Subcategory:
Resonators