Skip to main content

Camber Plates (Fixed) for 1999-2006 BMW 3-Series [E46]

We Price Match!

Speak with one of our Mod Experts

714.582.3330   or   Live Chat

We'll match or beat any competitor's price!

Some restrictions and exclusions apply.

Please see our full Price Match Policy for details.

$161.95
(No reviews yet) Write a Review
SKU:
TMSE46CMBPLTFXD

We Price Match!

Speak with one of our Mod Experts

714.582.3330   or   Live Chat

We'll match or beat any competitor's price!

Some restrictions and exclusions apply.

Please see our full Price Match Policy for details.
Shipping:
$8.50 (Fixed Shipping Cost)
Camber Plates (Fixed) for 1999-2006 BMW 3-Series [E46]

WARNING: product may contain chemicals known to the State of California to cause cancer, birth defects, and/or reproductive harm.
For more information, go to www.P65Warnings.ca.gov.

DISCLAIMER: Products that affect or remove vehicle emissions equipment (Intakes, Manifolds, Tuners, etc) that do not have a CARB EO number may not be available for sale in the state of California. Please contact us if you are unsure if a product is available for sale in California. ModBargains complies with all EPA and CARB regulations.

These “fixed” steel camber plates (legal for most stock class racing) will add negative camber and will reduce understeer during hard cornering and save the outside edge of your tire! These plates mount above the upper strut bearing and do not require removal of the bearing to install. This is a simple bolt on part. A must for Stock class racing!

Applications: 1999 - 2005 323, 325, 328, 330 (E46)

TMS E46 fixed camber plates are designed from knowledge gained from our highly successful campaigns with the E46 in the SPEED World Challenge series. These plates are offset for the best camber and caster combination for racing purposes. Camber gain ranges from -2.5° to -3.0°, depending on each individual car. While ride height is increased by 1/8”, the benefit of these plates far outweighs the minor ride height increase. The rate of camber change is virtually unaffected throughout the range of suspension travel, reducing the need for other suspension geometry correcting components. Material has also been added to increase surface contact area therefore reducing the strut tower deformation and increasing the strength of the strut towers. Fixed mount camber plates are legal for all BMWCCA classes and many SCCA classes. This is a simple bolt on part.

Click Here for Installation Instructions
Mod Category:
Suspension
Mod Subcategory:
Camber / Caster Plates