Benefits:
- Pull ahead of the competition with a Flat 6 Motorsports intake for your Macan S/GTS/Turbo.
- Give your engine that sweet induction noise everyone loves!
- Improve the visual appeal of your engine bay.
- Better gas mileage makes it easier to justify to your significant other.
Features:
- High Flow Air Filter with Nano-Fiber Dry Media Filtration
- Simple installation and OEM fit and finish
- Dyno verified +14.7whp on the Macan S (+24.9whp peak)
- Dyno verified +6.6whp on the Macan GTS (+13.4whp peak)
- 1/4 mile verified improvement of .27 sec and 2.2 mph higher trap speed
- Improved Turbo and Throttle Response
- Reduces Intake Air Temps (IATs) by 6.3% under full load
- Made in the USA
Applications:
- 2020+ Porsche Macan GTS
- 2020+ Porsche Macan Turbo
- 2019+ Porsche Macan S
Application Notes:
- As of 5/25/21 the carbon fiber version of the intake (PN: F6-INT-95B.2-S-CF) has been discontinued due to production challenges. The revised version of this intake system is made with the same OEM poly-blend plastic to preserve an OEM look.
- Includes: Filters & Plastic Ducts
- 19+ S / 20+ GTS & Turbo
- Installation Guide: F6-INT-95B.2-S
Description:
After studying and analyzing this design, Flat 6 Motorsports developed a solution that was cost-effective and simple to install and service. The first principle was to increase the airflow in both volume and velocity. This was achieved by opening up the duct that connects to the hood allowing more air flow into the airbox. CFD analysis was then used to optimize the design of the air filter design and material. Advanced simulation software showed that a bell-horn like design would both maximize filter surface area and most efficiently distribute air flow around the filter which provides 360 degrees of material compared to just 180 degrees on the OEM filter. This design creates high-pressure on the outside of the filter while minimizing pressure drop inside the filter, causing an increase in stable high velocity air that leads to the turbocharger.
