Benefits:
- Maximize your power gains and keep your Mazdaspeed3 pulling harder and longer!
- Don't let heat soak slow your Mazdaspeed3 down.
Features:
- Retains Stock Bumper Beam
- 5-Ply Silicone Couplers
- Works with Stock or Aftermarket BPV
- 2.5" Aluminum Tubing Powder Coated Wrinkle Black
- 24" x 6.5" x 3.5" Bar and Plate Core
Applications:
- 2010-2012 Mazda Mazda3 MPS WM
- 2010-2012 Mazda Mazdaspeed Axela WM
- 2010-2013 Mazda Mazdaspeed3 USDM
Application Notes:
- Emissions: This part is legal under the provisions of EPA’s Anti-Tampering Policy. COBB Tuning has established a reasonable basis (testing results) to verify that this product allows the vehicle to operate within legal Emissions: standards and is therefore legal to be sold for on-street use in all states that accept the legal provisions of the Clean Air Act and EPA’s Anti-Tampering Policy. NOT LEGAL FOR SALE OR USE IN CALIFORNIA ON ANY EMISSION CONTROLLED MOTOR VEHICLE. Testing with the California Air Resources Board, in order to achieve 50-state compliance, is pending. Once testing is complete with California, and an EO number is issued, this product will be updated to 50-state legal status.
- COBB (772625-BK) User/Instruction Manual
Description:
The 24"x6.5"x3.5" aluminum core with cast-aluminum end-tanks is extremely efficient while creating as little restriction as possible. 2.5" mandrel-bent aluminum tubing carries pressurized air to and from the intercooler and feature formed ends to eliminate hose blow-off. Five-ply silicone couplers and stainless steel t-bolt clamps are used throughout to further ensure reliable, leak-free joins. The process to ensure perfect fitment of the COBB Gen2 MS3 FMIC kit was just as rigorous as ensuring its high performance. This kit fits with the stock crash-bar in place, retaining factory passenger safety. The kit bolts into place with no cutting of the front bumper cover and only simple and straightforward trimming of the front undertray is required. Custom brackets allow perfect fitment in the tight confines behind the front bumper cover. The appearance of the COBB Gen2 MS3 FMIC is second to none, once again due to attention to detail. The intercooler core is visually striking, positioned dead-center in the bumper-cover opening, featuring a silver coating and casted COBB logos in the end tanks. The intercooler piping is powdercoated in a wrinkle black and includes integrated brackets with the COBB "C" logo. The five-ply silicone couplers also bear the COBB logo and are available in blue or black to best match your existing engine bay modifications. The COBB Gen2 MS3 FMIC is supported with Accessport Off-The-Shelf maps for intercoolers and a variety of other power-producing modifications. Simply install the COBB Gen2 MS3 FMIC kit, select an appropriate map from the extensive Mazda Accessport Off-The-Shelf Map Database, flash the ECU and go experience heat-soak-free power. Over and over and over! The COBB Gen2 MAZDASPEED3 FMIC is the ultimate combination of performance, quality and attention to detail.
Based on feedback received from MAZDASPEED3 enthusiasts, the development of this Front Mount Intercooler focused on three specific areas; high-efficiency, build quality and fitment. The final product is a tidy package that fits symmetrically in the front radiator opening, retains the stock crash-structure and has a thermal efficiency of over 80% through most of the rev-range with a maximum pressure-drop of less than 0.75psi at 21psi of boost.
