- Pull ahead of the competition with a Flat 6 Motorsports intake for your Macan S/GTS/Turbo.
- Give your engine that sweet induction noise everyone loves!
- Improve the visual appeal of your engine bay.
- Better gas mileage makes it easier to justify to your significant other.
- Pre-preg Dry Carbon Fiber with 2x2 weave construction Intake Ducts
- High Flow Air Filters with Nano-Fiber Dry Media Filtration
- Simple installation and OEM fit and finish
- Dyno verified 10whp on the Macan Turbo
- 1/4 mile verified improvement of .271 sec and 4.34 mph higher trap speed
- Improved Turbo and Throttle Response
- Made in the USA
- 2015 - 2018 Porsche Macan S / GTS (will not fit 2019 Macan S)
- 2015 - 2019 Porsche Macan Turbo
- Includes: Filters & Carbon Ducts
- Will not fit 19+ S
- Installation Guide: F6-INT-95B-S
After studying and analyzing this design, Flat 6 Motorsports developed a solution that was cost-effective and simple to install and service. The first principle was to increase the airflow in both volume and velocity. This was achieved by opening up the duct that connects to the hood allowing more air flow into the airbox. CFD analysis was then used to optimize the design of the air filter design and material. Advanced simulation software showed that a bell-horn like design would both maximize filter surface area and most efficiently distribute air flow around the filter which provides 360 degrees of material compared to just 180 degrees on the OEM filter. This design creates high-pressure on the outside of the filter while minimizing pressure drop inside the filter, causing an increase in stable high velocity air that leads to the turbocharger.